Number Of Beeps - Error; Good Read Delay - Honeywell Voyager XP 1470g Series User Manual

sync with one another. To change the number of beeps, scan the bar code below
and then scan a digit (1-9) bar code and the Save bar code on the
Chart. Default = 1.
Number of Beeps – Error
The number of beeps and LED flashes emitted by the scanner for a bad read or
error can be programmed from 1 - 9. For example, if you program this option to
have five error beeps, there will be five error beeps and five LED flashes in response
to an error. To change the number of error beeps, scan the bar code below and then
scan a digit (1-9) bar code and the Save bar code on the
Default = 1.

Good Read Delay

This sets the minimum amount of time before the scanner can read another bar
code. Default = 0 ms (No Delay).
Voyager 1470/1472 User Guide
* No Delay
Medium Delay (1,000 ms)
Number of Good Read Beeps/LED Flashes
Number of Error Beeps/LED Flashes
Programming
Programming Chart.
Short Delay (500 ms)
Long Delay (1,500 ms)
77