Reset The Custom Defaults; Menu Commands - Honeywell Voyager XP 1470g Series User Manual

The scanner scans until a bar code has been read, until the deactivate command is
sent, or until the serial time-out has been reached (see "Read Time-Out" on page 4-
79 for a description, and the serial command on

Reset the Custom Defaults

If you want the custom default settings restored to your scanner, scan the Activate
Custom Defaults bar code below. This resets the scanner to the custom default
settings. If there are no custom defaults, it will reset the scanner to the factory
default settings. Any settings that have not been specified through the custom
defaults will be defaulted to the factory default settings.
Note: If using a cordless system, scanning this bar code also causes both the scanner and
the base or Access Point to perform a reset and become unlinked. The scanner must
be placed in its base to re-establish the link. If using an Access Point, the linking bar
code must be scanned. See
additional information.
The charts on the following pages list the factory default settings for each of the
commands (indicated by an asterisk (*) on the programming pages).

Menu Commands

Selection
Product Default Settings
Set Custom Defaults
Reset the Custom Defaults
Program the Interface
Plug and Play Codes
Plug and Play Codes:
RS485
Voyager 1470/1472 User Guide
Activate Custom Defaults
Cordless System Operation
Setting
* Indicates default
Set Custom Defaults
Save Custom Defaults
Activate Custom Defaults
Keyboard Wedge:
IBM PC AT and Compatibles with CR
suffix
Laptop Direct Connect with CR suffix
RS232 Serial Port
IBM Port 5B Interface
IBM Port 9B HHBCR-1 Interface
IBM Port 17 Interface
page 184).
beginning on page 37 for
Serial Command
# Indicates a numeric
entry
MNUCDP
MNUCDS
DEFALT
PAP_AT
PAPLTD
PAP232
PAPP5B
PAP9B1
PAPP17
Page
8
8
9
11
12
12
12
12
13
175