Serial Trigger Mode; Read Time-Out; Presentation Mode; Presentation Centering - Honeywell Voyager XP 1470g Series User Manual

Serial Trigger Mode

You can activate the scanner either by pressing the trigger, or using a serial trigger
command (see
scans until a bar code has been read or until the deactivate command is sent. The
scanner can also be set to turn itself off after a specified time has elapsed (see
Read

Read Time-Out

Use this selection to set a time-out (in milliseconds) of the scanner's trigger when
using serial commands to trigger the scanner. Once the scanner has timed out, you
can activate the scanner either by pressing the trigger or using a serial trigger
command. After scanning the Read Time-Out bar code, set the time-out duration
(from 0-300,000 milliseconds) by scanning digits on the
scanning Save. Default = 30,000 ms.

Presentation Mode

Presentation Mode uses ambient light to detect bar codes. The LED dims until a
bar code is presented to the scanner, then the LED brightens to read the code. If
the light level in the room is not high enough, Presentation Mode may not work
properly.
Note: If you are using a cordless charge base in Presentation Mode, the battery will not
charge unless the power supply is plugged into the base's auxiliary power port.
Scan the following bar code to program your scanner for Presentation Mode.

Presentation Centering

Use Presentation Centering to narrow the scanner's field of view when it is in the
stand to make sure the scanner reads only those bar codes intended by the user.
For instance, if multiple codes are placed closely together, Presentation Centering
will insure that only the desired codes are read.
Note: To adjust centering when the scanner is hand-held, see Centering.
Voyager 1470/1472 User Guide
Trigger Commands
Time-Out, which follows).
on page 174). When in serial mode, the scanner
Read Time-Out
Presentation Mode
Programming Chart, then
79