4. Pull the connector out while maintaining pressure on the connector release
5. Replace with the new cable.
Change a Cordless Scanner Battery
1. Use the hinged wire or a flat head screwdriver to remove the screw from the end
2. Remove the end cap and remove the battery from the handle.
3. Insert replacement battery.
4. Replace end cap and screw it back on.
Troubleshoot a Corded Scanner
The scanner automatically performs self-tests whenever you turn it on. If your
scanner is not functioning properly, review the following Troubleshooting Guide to
try to isolate the problem.
Is the power on? Is the aimer on?
If the aimer isn't illuminated, check that:
Voyager 1470/1472 User Guide
clip.
Insert the connector into the opening and press firmly. The connector is keyed
to go in only one way, and will click into place.
cap.
CCB01-010BT-V1N Base:
End Cap
209