Alarm Sound Type - Honeywell Voyager XP 1470g Series User Manual

Access Point, when the base or Access Point connects to another scanner, or when
the alarm duration expires. To activate the alarm options for the scanner or the
base and to set the alarm duration, scan the appropriate bar code below and then
set the timeout duration (from 0-3000 seconds) by scanning digits on the
Programming
Note: The Access Point
does not have a base alarm.
Note: If you are out of range when you scan a bar code, you will receive an error tone even if
you do not have the alarm set. You receive the error tone since the data could not be
communicated to the base or Access Point or the host.

Alarm Sound Type

You may change the alarm type for the scanner or a CCB01-010BT-V1N base by
scanning the appropriate bar code below and then scanning a digit (0-7) bar code
and the Save bar code on the
The sounds are as follows:
Setting
0
1
2
3
4
5
6
7
Voyager 1470/1472 User Guide
Chart, then scanning Save. Default = 0 sec (no alarm).
Base Alarm Duration
Sound
3 long beeps, medium pitch
3 long beeps, high pitch
4 short beeps, medium pitch
4 short beeps, high pitch
single chirps, medium pitch
2 chirps, then 1 chirp, medium pitch
single chirps, high pitch
2 chirps, then 1 chirp, high pitch
Base Alarm Type
Scanner Alarm Duration
Programming Chart. Default = 0.
51