Chapter 9 - Serial Programming Commands; Conventions; Menu Command Syntax - Honeywell Voyager XP 1470g Series User Manual

CHAPTER
9
SERIAL PROGRAMMING
COMMANDS
The serial programming commands can be used in place of the programming bar
codes. Both the serial commands and the programming bar codes will program the
scanner. For complete descriptions and examples of each serial programming
command, refer to the corresponding programming bar code in this manual.
The device must be set to an RS232 interface (see
mands can be sent via a PC COM port using terminal emulation software.

Conventions

The following conventions are used for menu and query command descriptions:
parameter
[option]
{Data}
bold

Menu Command Syntax

Menu commands have the following syntax (spaces have been used for clarity
only):
Prefix [:Name:] Tag SubTag {Data} [, SubTag {Data}] [; Tag SubTag {Data}] [...] Storage
Prefix
:Name:
Voyager 1470/1472 User Guide
A label representing the actual value you should send as part of a
command.
An optional part of a command.
Alternatives in a command.
Names of menus, menu commands, buttons, dialog boxes, and win-
dows that appear on the screen.
Three ASCII characters: SYN M CR (ASCII 22,77,13).
This command is only used with cordless devices. It is used to specify
whether you're communicating with the base or the scanner. To send
information to the scanner (with the base connected to host), use
:Voyager_1472g: The default factory setting for a Voyager 1472g
page 12). The following com-
171