User-Specified Good Read Delay; Manual Trigger Mode; Led Illumination - Manual Trigger - Honeywell Voyager XP 1470g Series User Manual

User-Specified Good Read Delay

If you want to set your own length for the good read delay, scan the bar code below,
then set the delay (from 0-30,000 milliseconds) by scanning digits from the
Programming

Manual Trigger Mode

When in manual trigger mode, the scanner scans until a bar code is read, or until
the trigger is released. Default = Manual Trigger-Normal.

LED Illumination - Manual Trigger

If you wish to set the illumination LED brightness, scan one of the bar codes below.
This sets the LED illumination for the scanner when the trigger is pressed. Default =
High.
Note: The LEDs are like a flash on a camera. The lower the ambient light in the room, the
brighter the LEDs need to be so the scanner can "see" the bar codes
.
78
Chart, then scanning Save.
User-Specified Good Read Delay
Low
* High
* Manual Trigger - Normal
Voyager 1470/1472 User Guide
Medium