Menu Bar Code Security Settings; Set Custom Defaults - Honeywell Voyager XP 1470g Series User Manual

Menu Bar Code Security Settings

Honeywell scanners are programmed by scanning menu bar codes or by sending
serial commands to the scanner. If you want to restrict the ability to scan menu
codes, you can use the Menu Bar Code Security settings. Please contact the near-
est technical support office (see
mation.

Set Custom Defaults

You have the ability to create a set of menu commands as your own, custom
defaults. To do so, scan the Set Custom Defaults bar code below before scanning
the menu commands for your custom defaults. If a menu command requires scan-
ning numeric codes from the
sequence will be saved to your custom defaults. When you have entered all the
commands you want to save for your custom defaults, scan the Save Custom
Defaults bar code.
Note: When using a cordless system, the Custom Defaults settings apply to all workgroups.
Scanning the Save Defaults bar code also causes both the scanner and the base or
Access Point to perform a reset and become unlinked. The scanner must be placed in
its base to re-establish the link before any setup codes are entered. If using an Access
Point, the linking bar code must be scanned. See
beginning on page 37 for additional information.
You may have a series of custom settings and want to correct a single setting. To do
so, just scan the new setting to overwrite the old one. For example, if you had previ-
ously saved the setting for Beeper Volume at Low to your custom defaults, and
decide you want the beeper volume set to High, just scan the Set Custom Defaults
bar code, then scan the Beeper Volume High menu code, and then Save Custom
Defaults. The rest of the custom defaults will remain, but the beeper volume set-
ting will be updated.
8
Set Custom Defaults
Customer Support
Programming Chart, then a Save code, that entire
Cordless System Operation
Voyager 1470/1472 User Guide
on page xiii) for further infor-
Save Custom Defaults