Honeywell Voyager XP 1470g Series User Manual page 123

Search backward for a character
F9 Search the input message backward for "xx" character from the current cursor
position, leaving the cursor pointing to the "xx" character. Syntax = F9xx where xx
stands for the search character's hex value for its ASCII code.
Refer to the
decimal, hex and character codes.
Search forward for a non-matching character
E6 Search the input message forward for the first non-"xx" character from the current
cursor position, leaving the cursor pointing to the non-"xx" character. Syntax = E6xx
where xx stands for the search character's hex value for its ASCII code.
Refer to the
decimal, hex and character codes.
E6 Example: Remove zeros at the beginning of bar code data
This example shows a bar code that has been zero filled. You may want to ignore
the zeroes and send all the data that follows. E6 searches forward for the first char-
acter that is not zero, then sends all the data after, followed by a carriage return.
Using the bar code above:
Command string: E630F10D
E6 is the "Search forward for a non-matching character" command
30 is the hex value for 0
F1 is the "Send all characters" command
0D is the hex value for a CR
The data is output as:
37692
<CR>
Search backward for a non-matching character
E7 Search the input message backward for the first non-"xx" character from the
current cursor position, leaving the cursor pointing to the non-"xx" character.
Syntax = E7xx where xx stands for the search character's hex value for its ASCII code.
Refer to the
decimal, hex and character codes.
Voyager 1470/1472 User Guide
ASCII Conversion Chart (Code Page 1252),
ASCII Conversion Chart (Code Page 1252),
ASCII Conversion Chart (Code Page 1252),
beginning on page 216 for
beginning on page 216 for
beginning on page 216 for
107