Appendix A: Vav Zone Ii Points/Properties; Status - Carrier VAV Zone II Installation And Startup Manual

Appendix A: VAV Zone II Points/Properties

Appendix A: VAV Zone II Points/Properties
NOTE Engineering units shown in this document in the defaults and ranges are strictly for reference. You must
enter an integer only.

Status

Navigation: i-Vu® / Field Assistant:
Point Name/Description
Terminal Mode – The controller's current operating status.
Term Type – The type of zone terminal that the controller is installed on.
Space Temperature - Prime Variable – The space temperature value currently used for
control.
Primary Airflow – The current airflow measured through the primary air damper.
Damper Position – The current damper position.
Supply Air Temperature – Displays the current supply air temperature.
Heating Capacity – The current reheat capacity when the zone is configured for reheat.
Baseboard Heating Capacity – The current baseboard heat capacity when the zone is
configured for Combination Baseboard or Non-ducted Heat.
Outdoor Air Temperature – The current outdoor air temperature from a linked air
source, if available, or from another network source.
Fan – The status of the terminal fan if Term Type is Parallel Fan or Series Fan.
Space Relative Humidity – The current space relative humidity if Service Configuration
> Hardwired Sensor is set to RH Sensor or, you have a valid ZS RH sensor.
Indoor Air Quality CO2 (ppm) – The current IAQ value if Service Configuration >
Hardwired Sensor is set to CO2 Sensor or, you have a valid ZS CO
VAV Zone II Controllers
Installation and Start-up Guide
Properties Control Program
>
2 sensor.
70
Status
>
Range
R: Off
Heating
Warm-up
Vent
Cooling
Dehumidify
Reheat
Pressurize
Evacuate
Shutdown
IAQ Override
Air Balancing
R: Single Duct
Parallel Fan
Series Fan
R: -56 to 245°F
(-48.9 to 118.3°C)
R: 0 to 99999 cfm
(liters/second)
R: 0 to 100%
R: -56 to 245°F
(-48.9 to 118.3°C)
R: 0 to 100%
R: 0 to 100%
R: -56 to 245°F
(-48.9 to 118.3°C)
R: On/Off
R: 0 to 100%rh
R: 0 to 5000ppm
CARRIER CORPORATION ©2019
All rights reserved