Table of Contents
Advertisement
Setpoints for ZS Sensors
To configure setpoint properties for ZS sensors, CTRL+click anywhere on the Zone
Setpoints: graph at the top of the Setpoints section in order to access the Properties
popup.
In the popup, select the Properties > Sensor tab to configure ZS sensors for Setpoint
Adjust.
Edit Increment – Amount of offset in degrees for each press of the up or down arrows
on the ZS Sensor for setpoint adjustment.
Allow Setpoint Adjustment – Check to allow setpoint adjustments on the specified ZS
sensor.
Sensor Setpoint Adjust Option – Check to select the ZS setpoint adjustment display.
VAV Zone II Controllers
Installation and Start-up Guide
Appendix A: VAV Zone II Points/Properties
79
D:
1
R:
0.1
0.5
1
D:
(1) enabled
R:
disabled/enabled
D:
3
CARRIER CORPORATION ©2019
All rights reserved
Hide quick links:
Advertisement
Table of Contents
