Stopping A Recording Session; Downloading Recorded Data; Clearing Alarm Indication - AEMC Simple Logger II Series User Manual

Voltage and current data loggers

Hide thumbs Also See for Simple Logger II Series:

Table of Contents

4.4.2

Stopping a Recording Session

1. Press and hold the PRESS button. When the STOP (ORANGE) LED

lights up, release the button.

2. The GREEN LED will change from a double-blink to a single-blink,

indicating STANDBY mode.

The data will be retained, even if the instrument is turned OFF. The

recorded data is stored in Flash memory (maintained even in the absence

of batteries). The recorded data may be downloaded to a computer.

4.5

Recorded measurements stored in the instrument are transferred to

a computer via the download command in the SLII Control Panel. For

instructions on downloading data, see the Downloading Recorded Instru-

ment Data section inside the DataView

4.6

Clearing alarms can be performed in the STANDBY or RECORD mode.

1. Press and hold the PRESS button. When the ALARM (YELLOW) LED

lights up, release the button. The YELLOW LED will blink at a fast rate

for a period of five seconds.

2. Press the PRESS button for another 0.5 seconds to complete the

operation.

NOTE: This does not clear any stored alarms, only indications. Stored

alarms can only be cleared when memory is erased (see § 4.7).

Simple Logger

II Series

manual.

Table of Contents

Do you have a question about the Simple Logger II Series and is the answer not in the manual?