Connecting The Simple Logger ® Ii To A Computer; Turning The Unit On - AEMC Simple Logger II Series User Manual

• SLEEP mode:
button is not pressed for one minute. It will remain in this state until
either the button is pressed or the internal clock reaches the start
time for a scheduled recording.
• RECORD mode:
between sample sets. The slower the storage rate, the greater the
portion of time the instrument is in the low power state. Thus, the
slower the storage rate, the longer the instrument can record.
• OFF mode:
turn on at the time a recording is scheduled.
4.2 Connecting the Simple Logger
INSTALL DATAVIEW
Connect the Simple Logger
computer. Refer to the computer manual to locate the USB port on your
computer.
The logger can be connected to the computer during a recording session,
however, an additional drain on the batteries will occur to support the
active USB connection.
4.3

Turning the Unit On

Turn the instrument ON by performing one of the following:
• Press and hold the PRESS button for approximately 2 seconds.
Release the button after all five LEDs light up in unison.
The unit is now in the STANDBY mode (Green LED single-blinks).
NOTE: If all LEDs light instantaneously, the instrument was in SLEEP
mode. Releasing the PRESS button will show the status.
• Connect the instrument to a USB port on your computer and establish
communication with the instrument using DataView
remain ON while a communication link with the SLII Control Panel is
active (provided sufficient battery power is available during the com-
munication session).
Simple Logger II Series
®
The instrument enters the low power state if the
The instrument enters the low power state
The instrument enters the low power state and will
BEFORE CONNECTING TO THE COMPUTER.
®
II to a USB communication port on your
®
II to a Computer
®
. The logger will
®
19