Stopping A Recording Session; Downloading Recorded Data; Clearing Alarm Indication - AEMC Simple Logger II User Manual

4.3.2

Stopping a Recording Session

1. Press and hold the PRESS button. When the STOP (ORANGE) LED
lights up, release the button.
2. The GREEN LED will change from a double-blink to a single-blink,
indicating STANDBY mode.
The data will be retained, even if the instrument is in sleep mode. The
recorded data is stored in Flash memory (maintained even in the absence
of batteries). The recorded data may be downloaded to a computer.
4.4

Downloading Recorded Data

Recorded measurements stored in the instrument are transferred to a
computer via the download command in the Data Logger Control Panel.
4.5

Clearing Alarm Indication

Clearing alarms can be performed in the STANDBY or RECORD mode.
1. Press and hold the PRESS button. When the ALARM (YELLOW) LED
lights up, release the button. The YELLOW LED will blink at a fast rate
for a period of five seconds.
2. Press the PRESS button for another 0.5 second to complete the oper-
ation.
This does not clear any stored alarms, only indications. Stored alarms can
only be cleared when memory is erased (see § 4.6).
30
Simple Logger II Series
®