AEMC Simple Logger II Series User Manual page 28

Voltage and current data loggers

Hide thumbs Also See for Simple Logger II Series:

Table of Contents

NOTE: It is recommended to only press the RESET switch when the logger

stops responding to a normal press button control when not connected to

DataView

recording, downloading or being configured.

If the logger is not responding to a button press, make sure the unit has

sufficient battery power. If the battery voltage is below 1.7V, the unit will not

respond to a button press. In this condition, pressing the RESET switch

will not restart the unit.

It is recommended to download any desired session, then erase the

memory before starting a new recording.

NOTE: The resumption of the logger operation in the above situations

assumes that the RESET switch cleared the fault(s). The logger will not

resume normal operation if the fault condition still exists. The instrument

will try to recover normally. However, under certain conditions, the clock

and memory full state may be reset.

. It is not recommended to reset the instrument when the logger is

Simple Logger

II Series

Table of Contents

Need help?

Do you have a question about the Simple Logger II Series and is the answer not in the manual?