Inputs Connection And Configuration - urmet domus 1061/004 Installation And Programming Manual

A JP Inputs.self.by-pass..For.details,.see.paragraph.4...Inputs.connection
B JP1 Selection.between.balanced.and.nC.inputs..For.details,.see.paragraph.4...Inputs.connection
C F Rapid.fuse.for.+SIR.-.50V.3,15A.outputs
D F3 Bus.power.supply.rapid.fuse
E F1 +V.lines.power.supply.rapid.fuse.Inputs.self.by-pass..For.details,.see.paragraph.4.2.3 Outputs connection
F OK Programming.button.OK
↓
G Programming button NEXT (scroll)
H ESC Programming.button.ESC
I Programming.display
L Comb.connector.for.USB..0.interface.connection
TERMINAL PINS
BUS LA Bus.line,.data
LB Bus.line,.clock
+ Power.supply.1V,.positive
- Power.supply.1V,.negative
nO Relay..output.normally.open.contact
C Relay..output.common
nC Relay..output.normally.closed.contact
nO1 Relay.1.output.normally.open.contact
C1 Relay.1.output.common
nC1 Relay.1.output.normally.closed.contact
-BT Backup.battery.negative
+BT Backup.battery.positive
POWER C Power.supply.control.signal.
+ Power.supply.positive
- Power.supply.negative
-V 0V
+V +1V.
L1 Input.1
L Input.
L3 Input.3
L4 Input.4
-V 0V
+V +1V
-V 0V
SAB Tamper.line.4h.input
-V 0V
S System.state.output.and."memory.reset".for.detectors.and.sirens
+SR Power supply for external self-powered siren (maximum current: 650mA)
-V 0V
+SA nC.output.for.external.self-powered.siren
SIR nO.output.for.internal.siren
-V 0V
L5 Input 5 (present on the Ref. 1061/006 control panel only)
-V 0V (present on the Ref. 1061/006 control panel only)
L6 Input 6 (present on the Ref. 1061/006 control panel only)
- Control.panel.tamper.connection
TMP Control.panel.tamper.connection
All the terminal pins marked as –V have the same potential; the same for the terminal pins marked as +V. Terminal pins duplication has been
provided.to.make.wiring.operations.easier.

4.2.2 INPUTS CONNECTION AND CONFIGURATION

To.inputs.can.be.connected.magnetic.contacts,.presence.detectors,.rolling.shutters.detectors,.technological.detectors.and.rescue.detectors,.
with.the.following.exceptions:.
• To.input.1.can.not.be.connected.rolling.shutters.or.technological.detectors..
• The.intrusion.input.1.is.the.only.delayed,.all.the.other.intrusion.inputs.are.immediate.(for.further.details,.see.paragraph.5.4.2 Main programming
menu).
• The tamper input (SAB) is always active (H24); it is an immediate input.
16
DS1061-015B