urmet domus 1061/004 Installation And Programming Manual page 14

If the keypad is installed in a flush mounting box, it must be protected against tampering by mounting on the support the proper tamper
(1069/416), that must be connected to the SAB input of the keypad. For tamper can be used both available housings present on the support.
.
WARNING:.The protection for tamper spring (figure 18) must be cut both when the keypad is installed in the wall mounting box and in a flush
mounting box.
.
If.the.keypad.must.be.housed.in.the.provided.wall.mounting.box,.follow.the.instructions.below:.
1. Open one or both the cable apertures (figure 17, A).
. WARNING:.In the wall mounting box are not present pre-fractured apertures for external tubes or conduits.
.
2. Place the wall mounting box and mark the fixing holes (figure 17, B) and the hole for the anti-removal tamper (figure 17, C).
3. Drill the wall with a 5mm bit, put the provided anchor screws and fix the wall mounting box. For a correct installation, use 2 fixing holes at
least.and.the.hole.for.the.tamper..
.
4... Cut.the.TAMPER.protection.on.the.keypad.bottom.to.release.the.spring.
14
B
A
B
Figure 17 – Wall mounting box for keypad
Figure 18 – Tamper protection
B
A
B
C
DS1061-015B