Installation; Alarm.control.panel; Fixing - urmet domus 1061/004 Installation And Programming Manual

3. INSTALLATION

3.1 ALARM CONTROL PANEL

3.1.1 FIXING

Control panel opening.
Open the control panel by loosing with the provided screwdriver with exagonal tip (allen spanner), the two flush mount fixing screws, by sliding
up the lid, in order to release the ledges (figure 1).
Cable apertures opening
On the control panel bottom, open the pre-fractured apertures for cables (power supply, detectors, sirens, bus, telephone line, audio line). Cable
number.and.kinds.depend.on.the.system.to.be.realized.
D
C D
A
WARNING:.When opening the pre-fractured apertures, take care not to damage the motherboard. For safety's sake, it is suggested to remove
the motherboard before opening apertures, as shown in the paragraph Motherboard removal.
Wall mounting
The.control.panel.must.be.placed.in.an.interior,.in.a.zone.protected.by.the.alarm.system,.on.a.dry,.level.wall.
The control panel is provided with 4 fixing holes (A and B), accessible without removing the motherboard, and another fixing hole, accessible by
removing the motherboard (C). The hole C must be used only if one or both the upper fixing holes can not be used.
DS1061-015B
Figure 1 – Control panel opening
C
A
C
C
Figure 2 – Pre-fractured apertures for cables
A
B
Figure 3 – Control panel fixing holes
D
D
A
– Aperture for flush mount tube
A
B
– Aperture for flush mount tube (electric power supply)
B
B
C – Aperture for external tube A
D
– Aperture for cable trunking
D
D
A (It can not be used with 7A/h batteries)
D
D
C
B
B
9