Management.keypad - urmet domus 1061/004 Installation And Programming Manual

The electronic key reader and the proximity readers can be directly put on supports for flush mounting or wall mounting boxes of Simon Urmet
Nea residential series; they take up one module space. With specific adapters, present in catalogue, it is also possible to put them on flush
mounting.or.wall.mounting.boxes.of.the.most.common.residential.series.(BTicino.Living.International.and.Living,.Vimar.Plana.and.Idea,.Gewiss.
Playbus); also in this case, they take up one module space. Readers must be placed in a dry place, protected by bad weather conditions.
According to CEI 79.2 standards, the readers must be kept in self-protected housing (housings with anti-removal and anti-opening tamper). If
are used supports and plates of Simon Urmet Nea catalogue, a protection tamper (1069/416), designed for this purpose, is already available.
The.different.tampers.must.be.connected.in.series.
Reader
Nea plate
WARNING:.In order to connect to the control panel tamper line the tamper that protects the electronic key reader or the proximity reader, it is
necessary to lay a suitable line. So, if readers are installed, it is suggested to use for the bus a 6-wire cable and use 2 of them for the tamper
line.
3.3 MANAGEMENT KEYPAD
The management keypad can be placed both in a 3-modules flush mounting box (type 503) and in the provided wall mounting box. The keypad
must.be.placed.indoor,.in.a.zone.protected.by.the.alarm.system.
The.keypad.is.provided.with.the.following.screws:
no..3.. M.3,5.x..for.wall.mounting.with.screw.anchors.
No. 2 M 3,5 x 19 for frame fixing on box Mod. 503
No. 2 M 3,5 x 10 for fixing on wall mounting box
Keypad
The keypads address is configured with their rotary switch and no other confirming operations are needed. The address can have a value from 0
to 3 and must be unique for the group of keypads. It is suggested to number in sequence the keypads during their installation. In a system can
be.present.up.to.4.keypads.
DS1061-015B
Nea support
Ref. 1069/416
Nea adapter
Figure 14 – Tamper for Simon Urmet Nea supports and plates
.
Nea support
Ref. 1069/416
Nea plate
Figure 15 – Keypad mounting
Figure 16 – Position of rotary switch and valid addresses
.
13