urmet domus 1061/004 Installation And Programming Manual page 28

OK
ESC
Test call.
Enable / disable SMS
When an event occurs, the telephone communicator starts sending alarm calls to every telephone number associated to the event, in
sequence.
If.in.the.control.panel.there.are.both.the.PSTn.telephone.communicator.and.the.GSM.module,.with.Primary.telephone.channel.parameter,.it.is.
possible.to.identify.which.device.must.be.used.as.priority.channel.for.alarm.calls..If.the.primary.telephone.channel.is.not.available,.(for.example.
for PSTN line failure or no GSM network), is automatically used the other one.
Telephone number entering.
To.enter.a.telephone.number,.follow.the.instructions.below:.
1.. Press.OK button to select the desired memory location (t1, t2 ... t8).
2. Enter the telephone number, using the "arrow" button; digits scroll in sequence, character P inserts a 1 second pause.
3.. Press.OK button to confirm.
4.. Repeat.from.step.1.until.the.whole.telephone.number.has.been.entered.
5.. Keep.OK button pressed for 2 seconds to confirm the whole telephone number. The telephone number scrolls on LCD display in order to
check.it.and.appears.the.dot.down.on.the.right..
Check of a telephone number already programmed
To.check.a.telephone.number.already.programmed.(the.stored.telephone.numbers.are.indicated.by.the.dot.down.on.the.right.corner.of.LCD.
display), press OK.button..The.number.will.appear.on.display,.one.digit.at.a.time,.blinking.on.the.right..
Telephone number deleting
Select the desired memory location (t1, t2 ... t8) and keep OK.button.pressed.for..seconds..The.LCD.display.blinks.for.3.times.and.disappears.
the.dot.down.on.the.right.
.
WARNING:.Using a PC and the suitable software, it is possible to customize an higher number of telephone parameters. For further information,
see paragraph 5.5.3 Telephone communicators configuration.
8
OK
...
ESC
230V
mains return
OK
...
ESC
Low
battery
OK
...
ESC
Charged
battery
OK
...
ESC
Failure
OK
ESC
PSTN
...
line
OK
...
ESC
GSM
network
Press OK button to start the GSM coverage test.
00 – No GSM field (f<-100dBm)
01 – Low GSM field (-100dBm<f<-95dBm)
02 – Medium GSM field (-95dBm<f<-90dBm)
GSM
03 – Good GSM field (-90dBm<f<-85dBm) GSM
field test
04 – Excellent GSM field (f>-85dBm)
When the OK button is pressed to enable or disable
the SMS sending (toggle selection), the LCD display
blinks for 3 times. The dot down on the right
disappears if SMS are disabled, appears again if SMS
are enabled.
When the OK button is
pressed to associate or
disassociate the telephone
number to the event (toggle
selection), the LCD display
blinks for 3 times. The dot
down on the right disappears
if the telephone number is
disassociated, appears again
if the telephone number is
associated.
Press OK button to start the
test call on the selected
telephone number.
Press ESC button to stop
the call.
DS1061-015B