Table of Contents
Advertisement
5 System Settings
Communication Mode
Set the communications mode. You can select [G3 (Auto)] or [F4800].
When the destination is specified by an address book entry with the communications mode
set, it is not possible to change the communications mode in the [Fax/iFax] screen.
Note
Resolution
Set the transmission image quality.
Select from [Panel] (image quality selected on the control panel), [Standard], [Fine],
[Superfine (400 dpi)], and [Superfine (600 dpi)].
Cover Note
Select whether to send transmissions with a cover note attached. If attached, specify
comments relating to the recipients and sender to be included in the cover notes.
Comments must be registered in advance.
For information on comment registration, refer to "Comments" (P.129).
1
Select [Off] or [On].
2
When [On] is selected, select
[Comment].
3
Select [Recipient's Comment].
5
4
Select [On], and select a comment
from the displayed list of
comments.
Note
5
Select [Save].
6
To insert a [Sender's Comment], repeat the procedure of Steps 4 and 5.
Maximum Image Size
Select the maximum storage size from [A3], [B4], and [A4], to match the recipient's paper size
or processable profile.
Delayed Start
Set whether or not to use a delayed start transmission.
If the machine's system clock is set to the 24-hour display, [AM] and [PM] do not appear. For
information on the system clock, refer to "6 System Settings" > "Common Settings" > "Machine Clock/
Timers" in the Administrator Guide.
Remote Mailbox
Select whether to use mailbox communications. Note that when using mailbox
communications, the other party's mailbox number and passcode must be set in advance.
126
• [G4 Auto] appears when an Internet Fax Kit is installed. For iFax, the setting applies to the
section between the fax gateway and the recipient fax.
• Select [
] to return to the
previous screen or [
] to
move to the next screen.
Advertisement
Table of Contents
