HDL M/R4.16.1 Manual page 41

HDL KNX / EIB
---Running automatically after bus voltage recovery
---Forced position('1'-forced,'0'-cancel)
>>:--Valve of PWM
>>:--Forced cancel operation
Options: Stop heating
Stop heating:When cancel forced operation,and stop heating.
Return to normally heating valve:When cancel forced operation,and
_____________________________________________________________________________________
Guangzhou Hedong Electronic Co.,Ltd (HDL)
This parameter will set the valve of the PWM (pulse width).
Options: 0%(OFF)
10%(26)
20%(51)
30%(77)
40%(102)
50%(128)
60%(153)
70%(179)
80%(204)
90%(230)
100%(ON)
Options: No
Defined valve
Recvery
No: PWM not running automatic power on.
Defined valve: PWM running by set valve.
Recvery: PWM automatic running by last save valve
Options: No
Yes
No:No need force run.
Yes:Need forced run.
The valve PWM of forced position.
Return to normally heating valve
return to normally heating valve.
Switch Actuators
www.hdlchina.com
41/58