Table of Contents
Advertisement
MAINTENANCE
Fasteners
Before operating your Brillion machine, check all
hardware for tightness. Use the Tightening Torque Table
below as a guide. See Page 4-1.
After a few hours of use, check entire machine and
tighten any loose nuts or bolts. Daily or periodic checks
should be made thereafter.
When replacing bolts, be sure to use fasteners of equal
grade.
Tires
Recommended tire sizes are 7.6 x 15-6 Ply Tire and
should be inflated to 40 PSI.
When Re-Installing the Wheel Nuts tighten to 50
foot-pounds using the sequence in Figure 4-1. Then
tighten to full torque of 85-100 ft-lbs.
Figure 4-1: Stud Tightening Sequence
Lubrication Maintenance
Wheel Hub Lubrication should be performed at the
beginning of every season of use. Check the wheel
bearings periodically for excessive end play.
Grease Wheel Hubs every 50 hours. See Figure 4-2.
Grease Spring Shank Clamp every 10 Hours to prevent
seizure. See Figure 4-3.
4-2
Figure 4-2 Wheel Hub
Figure 4-3 Spring Shank
7D525
Advertisement
Table of Contents
