Table of Contents
Advertisement
Engineering
8
Detector line
8.4.6.3 View type A dependency
8.4.7 Reset detection module
92 | 124
Building Technologies
Fire safety
The 'View typeA dependency' function is used to view all devices which have
type A dependency activated.
1. Press
on the keypad.
a The 'Main menu' window is open.
2. Select 'Engineering' and press
a The 'Engineering' window is open.
3. Select 'Detector line' and press
a The 'Detector line' window is open.
4. Select 'View / locate' and press
a The 'View / locate' window is open.
5. Select 'View typeA dependency' and press
a A list of all zones with activated type A dependencies is displayed.
6. Select one zone and press
a The details of the type A zone are displayed as follows.
View typeA dependency
Auto alarm zone 5
Type A inhibit time(sec) 30
The 'Type A function' can be configured by 'FC360 Panel Configurator'.
The 'Reset detection module' function is used to reset the detection module from
the menu when the detection module reports a fatal fault.
1. Press
on the keypad.
a The 'Main menu' window is open.
2. Select 'Engineering' and press
a The 'Engineering' window is open.
3. Select 'Detector line' and press
a The 'Detector line' window is open.
4. Select 'Reset detection module' and press
a A confirmation dialog window is open.
5. Press
to confirm.
a A message 'Line startup is in progress...' is displayed.
a The detection module is reset and the fatal fault disappears once the above
message disappears.
.
.
.
.
.
L3
.
.
.
A6V10421795_en--_g
2016-11-18
Advertisement
Table of Contents
