Table of Contents
Advertisement
Building Technologies
Fire safety
w The power supplies (mains and battery) are disconnected.
w All connectors are disconnected (label cables before disconnecting them).
w RS232 / RS485 module is removed if installed.
w The mainboard is removed. Refer to document A6V10450593, see chapter
'Applicable documents [➙ 9]'.
1. Mount the mainboard (3) with the 6 screws (2) to the threaded bolts (1) that are
embedded in the rear panel.
2. Re-install RS232 / RS485 module that may have been removed.
3. Connect all connectors according to the label.
4. Switch on power supply.
5. Set country and language. Refer to chapter 'Startup panel [➙ 97]'.
6. Check firmware version to be sure the latest version is installed. It is an integral
part of the 'FC360 Desktop Editor' which can be downloaded from
www.siemens.com/cerberus-fit
7. Restore configuration to panel if you have it on PC. Otherwise you have to
execute auto configure detector line and configure the system manually. Refer
to chapter 'Restore configuration to panel [➙ 104]', 'Auto configure detector
line [➙ 97]', 'Configure the system manually [➙ 98]'.
8. Function test. Refer to chapter 'Function test [➙ 100]'.
9. Completing work. Refer to chapter 'Completing work [➙ 100]'.
See also
2 Auto configuration [➙ 89]
Installation
5
Spare Parts
53 | 124
A6V10421795_en--_g
2016-11-18
Advertisement
Table of Contents
