Configure Audio Warning; Notify Surveillance Center; Configure E-Mail Linkage; Trigger Alarm Output - HIKVISION DS-7608NXI-I2/8P/4S User Manual

Auto-switch will terminate once the alarm stops and go back to the live view interface.

Configure Audio Warning

The audio warning enables the system to trigger an audible
1) Go to System > Live View > General.
2) Enable the audio output and set the volume.
3) Go to the Linkage Action interface of the alarm detection (e.g., motion detection, video
tampering, etc.)
4) Select the Audio Warning alarm linkage action.

Notify Surveillance Center

The device can send an exception or alarm signal to the remote alarm host when an event occurs. The
alarm host refers to the PC installed with client software (e.g., iVMS-4200, iVMS-5200).
1) Go to System > Network > Advanced > More Settings.
2) Set the alarm host IP and alarm host port.
3) Go to the Linkage Action interface of the alarm detection (e.g., motion detection, video
tampering, etc.)
4) Select the Notify Surveillance Center.

Configure E-mail Linkage

The system can send an e-mail with alarm information to a user or users when an alarm is detected.
Chapter 16.7 Configure E-mail
Please refer to
1) Go to System > Network > Advanced.
2) Configure the E-mail settings.
3) Go to the Linkage Action interface of the alarm detection (e.g., motion detection, video
tampering, etc.)
4) Select the Send E-mail alarm linkage action.

Trigger Alarm Output

The alarm output can be triggered by the alarm input, motion detection, video tampering detection,
line crossing detection, and all other events.
1) Go to the Linkage Action interface of the alarm input or event detection (e.g., motion detection,
beep
when an alarm is detected.
for details of E-mail configuration.
DS-76xx-I2/xP/4S NVR UM
91