HIKVISION DS-7608NXI-I2/8P/4S User Manual page 156

No image displayed on the monitor following normal startup
Possible reasons include:
No VGA or HDMI connections.
Connection cable is damaged.
Input mode of the monitor is incorrect.
1) Verify that the device is connected to the monitor via HDMI or VGA cable.
2) If not, please connect the device with the monitor and reboot.
3) Verify the connection cable is good.
4) If there is still no image display on the monitor after rebooting, please check if the connection
cable is good, and change a cable to connect again.
5) Verify Input mode of the monitor is correct.
6) Please check the input mode of the monitor matches with the output mode of the device (e.g.
if the output mode of device is HDMI output, then the input mode of monitor must be the HDMI
input). And if not, please modify the input mode of monitor.
7) Check if the fault is solved in Step 1 to Step 3.
8) If it is solved, finish the process. If not, please contact a Hikvision engineer for further
assistance.
A "Di-Di-Di-DiDi" warning sounds after a newly bought device starts up
Possible reasons include:
No HDD is installed in the device.
The installed HDD has not been initialized.
The installed HDD is not compatible with the device, or is broken.
1) Verify that at least one HDD is installed in the device.
If not, install a compatible HDD.
If you do not wish to install an HDD, go to Menu > System > Event > Normal Event >
Exception, and uncheck the "HDD Error" Audible Warning checkbox.
2) Verify that the HDD is initialized.
1) Go to Menu > Storage > Storage Device.
2) If the status of the HDD is "Uninitialized", please check the corresponding HDD
checkbox and click the "Init" button.
3) Verify that the HDD is detected or is in good condition.
1) Select Menu > Storage > Storage Device.
2) If the HDD is not detected or the status is "Abnormal", please replace the dedicated
HDD according to requirements.
4) Check if the fault is solved by performing steps 1 to 3. If it is solved, finish the process. If not,
please contact a Hikvision engineer for further assistance.
The status of the added IP camera displays as "Disconnected" when it is connected through Private
Protocol.
DS-76xx-I2/xP/4S NVR UM
156