Ir Remote Control Operations; Pairing (Enabling) The Ir Remote To A Specific Device (Optional); Unpairing (Disabling) An Ir Remote From A Device - HIKVISION DS-7608NXI-I2/8P/4S User Manual

IR Remote Control Operations

The device may also be controlled with the included IR remote control, as shown in Figure 1-2.
Batteries (2 × AAA) must be installed before operation.
The IR remote is set at the factory to control the device (using default Device ID# 255) without any
additional steps. Device ID# 255 is the default universal device identification number shared by the
devices. You may also pair an IR Remote to a specific device by changing the Device ID#, as follows:

Pairing (Enabling) the IR Remote to a Specific Device (optional)

You can pair an IR Remote to a specific device by creating a user-defined
Device ID#. This feature is useful when using multiple IR Remotes and
devices.
On the device:
1) Go to System > General.
2) Type a number (255 digits maximum) into the Device No. field on
the IR Remote:
3) Press the DEV button.
4) Use the Number buttons to enter the Device ID# that was entered
into the device.
5) Press Enter button to accept the new Device ID#.

Unpairing (Disabling) an IR Remote from a Device

To unpair an IR Remote from a device so that the unit cannot control any
device functions, proceed as follows:
Press the DEV key on the IR Remote. Any existing Device ID# will be
erased from the unit's memory and it will no longer function with the
device.
(Re)-enabling the IR Remote requires pairing to a device. See
"Pairing the IR Remote to a Specific device (optional)" section above.
The keys on the remote control closely resemble the ones on the front panel. See Table 1.4.
DS-76xx-I2/xP/4S NVR UM
Figure 1-2 Remote Control
22