Chapter 6 PTZ Control
PTZ Control Wizard
Before you start
Please make sure the connected IP camera supports the PTZ function and is properly connected.
Purpose
Follow the PTZ control wizard to guide you through the basic PTZ operation.
1) Click
on the quick settings toolbar of the PTZ camera live view. The PTZ control wizard
pops up as below.
2) Follow the wizard to adjust the PTZ view, focus, and zoom in/out the
camera.
3) (Optional) Check Do not show this prompt again
4) Click OK to exit.
Configure PTZ Parameters
Purpose
Follow the procedure to set the parameters for PTZ. The configuration of the PTZ parameters should be
done before you control the PTZ camera.
1) Click
on the quick settings toolbar of the PTZ camera live view. The PTZ control panel
displays on the right of the interface.
2) Click PTZ Parameters Settings to set the PTZ parameters.
Figure 6-1 PTZ Control Wizard
.
DS-76xx-I2/xP/4S NVR UM
46