Chapter 16 Network Settings; Configure Tcp/Ip Settings - HIKVISION DS-7608NXI-I2/8P/4S User Manual

Chapter 16 Network Settings

Configure TCP/IP Settings

Purpose
TCP/IP settings must be properly configured before you can operate the device over network.
1) Go to System > Network > TCP/IP.
2) Select Net-Fault Tolerance or Multi-Address Mode under Working Mode.
Net-Fault Tolerance: The two NIC cards use the same IP address, and you can set
the main NIC to LAN1 or LAN2. When one NIC card fails, the device will automatically
enable the other standby NIC card to ensure normal running of the system.
Load Balance: The two NIC cards share the same IP address and the total
bandwidth load, which enables the system to provide a two Gigabit network
capacity.
Multi-address Mode: The parameters of the two NIC cards can be configured
independently. You can select LAN1 or LAN2 under Select NIC for parameter
settings. You can select one NIC card as the default route. When the system is
connected to the extranet, the data will be forwarded through the default route.
3) Configure other IP settings as needed.
Check Enable DHCP to obtain IP settings automatically if a DHCP server is available on the network. The
valid range of the MTU value is 500 to 9676. .
4) Click Apply.
Figure 16-1 TCP/IP Settings
DS-76xx-I2/xP/4S NVR UM
123