Menu Control System - T+A VSP 1250 R User Manual

Table of Contents

Available languages

The VSP 1250 R features a convenient on-screen menu for adjusting all the picture parameters. With the help of this

menu you can optimise the picture reproduction and adjust it to suit your personal preferences.

The picture settings which you select in the menu always apply exclusively to the picture source which is currently active.

The settings are stored separately in the VSP 1250 R for each picture source. When you switch source devices, the

VSP 1250 R calls up the picture values for the new source from its memory, and automatically restores all the picture

parameters exactly as you originally set them for that source. This allows you to compensate deliberately for picture

differences between individual source devices, such as variations in contrast or colour reproduction.

Operating the B

B setup menu using the F6

system remote control handset

The first step is to switch the B surround receiver /

surround decoder to VSP 1250 R operation. This is done

with a brief press on the 

handset. The VSP 1250 R operating mode is confirmed

by the appearance of the message '

displayed on the surround receiver's integral display and

on the video monitor.

After switching to VSP 1250 R operation briefly press the

 button to open the menu control system.



You can now select any menu entry on the monitor using

the 

 / 





 buttons.



If you wish to change a setting, first activate the desired

menu entry by pressing the 

appears, with the currently set value highlighted in

orange. You can now change the setting using the 

 buttons. Once you have determined the correct



setting, press the 

 button to confirm your choice;



the setting is now stored for the currently active picture

source.

Press the 

 button on the F6 handset to leave a



menu point or any sub-menu.

To close the menu please press the 

necessary several times) until the menu disappears from

the screen.