Using A Remote Control Handset With The Vsp 1250 R In A  System - T+A VSP 1250 R User Manual

Using a remote control handset with the VSP 1250 R in a 
In a B home cinema
system the B F6 handset
provides remote control of
all the functions of the
VSP 1250 R. All the settings
you select are displayed on
the machine's integral
display, and on any TV set
connected to the system.
 
 
A brief press on the 
processor mode.
A brief press on the button calls up the message '
display of the SR 1535 R and on your video monitor. All the buttons on
the remote control handset now apply to the VSP 1250 R, enabling
you to make any adjustments you wish to the VSP 1250 R itself.
Note:
A brief press on the 
operations. The message '
of the receiver and source device is restored.
After switching to video processor mode the aspect ratio can be
adjusted by pressing the 
button cycle through all the different aspect ratios the VSP 1250 R
provides.
   
Within the Setup menu
Activates a menu point prior to adjustment. When the settings are
correct, this button terminates the adjustment function and accepts the
set value.
Outside the Setup menu
A brief press on this button calls up an INFOBOX on your video
monitor, displaying the current settings of the VSP 1250 R in a clear
form. Pressing the 
   /      Selects a menu entry.
  /   Changes a setup value in the menu.
   
Note:
You must activate the menu point by pressing the 
before you can change its value.
   
Switches back to normal operations. The message '
disappears, and normal control of the receiver and source device is
restored.
Within the Setup menu
Exits a menu adjustment without storing the new value. Jumps to the
next higher menu level. When in the top menu level (MAIN MENU)
closes the menu control.
   
A press on this button opens the menu control system of the
VSP 1250 R (see chapter 'Menu control system').
   
A brief press on this button switches the Overscan function on and off.
 
 
This button has the same function as the 
machine's front panel.
Note:
In Direct mode no superimposed on-screen messages (MENU etc.)
are displayed.
42
 button switches the  system to video  
 button switches back to normal
 
VIDEOPROC VIDEOPROC
VIDEOPROC VIDEOPROC ' disappears, and normal control
 button. Multiple presses on this
 
  button again will close the INFOBOX. 
 system
 
VIDEOPROC VIDEOPROC VIDEOPROC VIDEOPROC ' on the
 button  
VIDEOPROC VIDEOPROC '
VIDEOPROC VIDEOPROC
  button on the 