T+A VSP 1250 R User Manual page 69

Problem: No picture with S-Video (YC) video
sources.
Cause 1: Incorrect input selected on the VSP 1250 R.
Remedy: Switch the VSP 1250 R to the AV2 input.
Cause 2: YC video cable not connected between the
surround receiver and the VSP 1250 R
(AV2 input).
Remedy: Connect the appropriate cable.
Cause 3: The correct type of video signal for the
source concerned has not been assigned
at the surround receiver.
Remedy: Set the video signal type to S-Video
('VIDEO inputs'
SR 1535 R / DD 1535 R).
Problem: No picture with Component (YUV) video
sources.
Cause 1: Incorrect input selected on the VSP 1250 R.
Remedy: Switch the VSP 1250 R to the AV3 input.
Cause 2: YUV video cable not connected between
the surround receiver and the VSP 1250 R
(AV3 input).
Remedy: Connect the appropriate cable.
Cause 3: The correct type of video signal for the
source concerned has not been assigned
at the surround receiver.
Remedy: Set the video signal type to YUV ('VIDEO
inputs' setup menu on the SR 1535 R /
DD 1535 R).
Problem: Pictures from analogue video sources
appear duplicated (two images side-by-
side).
Cause: The picture source or the surround receiver
connected
delivering analogue video signals with
'Progressive Scan'.
Remedy: Switch the source or receiver to generate
normal half-images (interlaced video).
Problem: Pictures are displayed with incorrect
colours.
Cause: The monitor has detected the incorrect
colour format (RGB / YUV), or is configured
to the wrong colour format.
Remedy: Adjust your monitor's colour format so that
the colours are displayed correctly (see the
operating instructions supplied with your
monitor).
setup menu on
to the VSP 1250 R
Sound problems
Problem: With
receiver only reproduces stereo sound.
Cause: Input sound format incorrectly set on the
VSP 1250 R.
Remedy: Select the 'ALL' setting in the AUDIO
SETUP sound format menu.
Problem: A video monitor connected to the HDMI
output produces no sound.
Cause 1: The VSP 1250 R is not receiving a sound
signal from the surround receiver.
the
Remedy: Connect the digital sound input of the
VSP 1250 R to a digital sound output on
your receiver.
Cause 2: The sound passed to the VSP 1250 R is in
a format which the display device cannot
process (e.g. Dolby Digital Surround).
Remedy: Set the digital sound output of your receiver
and / or source device so that it generates
a sound format which is compatible with the
video monitor (e.g. PCM).
are
69
HDMI sources the surround