Table of Contents
Advertisement
Available languages
Available languages
with a B
If you operate your VSP 1250 R in conjunction with an
SR 1535 R (*) or DD 1535 R (*), virtually all the operating
processes are completely automated.
Simply switch your video monitor on, and select the
HDMI input on the monitor (or the DVI input if you are
using DVI wiring).
Note:
Many models of video monitor offer an
automatic power-on feature which switches the
device on as soon as an HDMI signal is present
at the input.
Now select the desired source - e.g. DVD - on the B
system. There will be a brief transition delay, then the
picture from the DVD player will appear on the monitor,
and you will hear the appropriate sound. When the
source is selected, the system invokes your preferred
picture and sound settings for this device (see 'Source-
specific presets' in the chapter entitled 'Useful
information / Glossary').
All you need to do now is briefly press the
on your F6 remote control handset, and the programme
begins.
(*) Note:
If the VSP 1250 R is to work properly with this
system combination, the B surround receiver
or decoder must be fitted with a certain
minimum version of the software. For more
information on this please refer to the chapter
entitled 'Specification'.
Using the VSP 1250 R in practice
Using the unit in conjunction
B SR 1535 R surround receiver or DD 1535 R decoder
B
B
button
Adjusting the aspect ratio
The only function which you may need to adjust
occasionally when using a complete B system
incorporating the SR 1535 R or DD 1535 R is the aspect
ratio setting (4 : 3 / 16 : 9).
If at any time the picture from the source device is not
displayed correctly on your monitor, please select the
appropriate conversion factor for the current source by
pressing the ASP button on the front panel of the
VSP 1250 R (see also the chapter entitled 'Useful
information / Glossary').
Alternatively you can adjust the aspect ratio conveniently
from your armchair using the remote control system. This
is the procedure:
• A brief press on the
switches the system to VSP 1250 R mode. The
message '
VIDEOPROC
VIDEOPROC
VIDEOPROC
VIDEOPROC
display of the SR 1535 R and on your video monitor, to
indicate that you can control the VSP 1250 R using the
remote control handset.
• Now you can adjust the aspect ratio by pressing the
button, repeatedly if necessary.
• Once you have set the appropriate aspect ratio,
another brief press on the
VSP 1250 R control mode.
Supplementary settings
Occasionally you may wish to change other settings,
such as contrast, brightness etc. You can do this directly
at any time by using the buttons on the front panel of the
machine.
Alternatively you can - of course - use the remote control
handset. The procedure is exactly as described above:
• Switch to VSP 1250 R mode by pressing the
button.
• Carry out the adjustment required using the direct
buttons on the F6 handset (see the chapter entitled
'Remote control of the VSP 1250 R') or using the
Setup menu (see the chapter entitled 'Menu control').
• Press the
button to conclude VSP 1250 R
control mode.
Note:
The system remembers all the picture and
sound settings which you have selected for your
B system; they are stored individually for
each source device.
For more information on this subject please
refer to the section 'Source-specific presets' in
the
chapter
information'.
44
button on the F6 handset
' now appears on the integral
button concludes
entitled
'Glossary /
Useful
Advertisement
Chapters
Table of Contents
