Source Selection; Preamplifier Outputs; System Settings; Remote Control Receiver - T+A DAC 200 User Manual

4

Source selection

ANALOG
USB
S/P-DIF
OPT
AES
BNC
HDMI
ARC
5

Preamplifier outputs

OUT
6

System settings

MENU
7

Remote control receiver

8

Volume control and menu operation

VOLUME
SELECT / OK
8

Display

Currently selected source
Set volume with bar graph
Selects the analog input ANALOG IN (RCA).
Selects the digital USB DAC input USB IN.
Selects the coaxial digital inputs S/P DIF 1 and 2.
Press the button again to switch between 1 and 2.
Selects the optical TOSLINK digital inputs Optical 1 and Optical 2.
Press the button again to switch between 1 and 2.
Selects the digital AES/EBU and the digital BNC input.
Press the button again to toggle between the two inputs.
Selects the digital inputs HDMI 1, HDMI 2 or the return channel ARC.
To switch between the inputs, press the button repeatedly if necessary.
A brief press switches the preamplifier outputs ANALOG 1 (XLR) and ANALOG 2
(Cinch / RCA) off and on (MUTING function). The LED above the button indicates the
current switching state.
A brief press of this button opens and closes the tone settings.
(see chapter System settings).
A long press opens and closes the system settings menu.
(see chapter System settings).
When operating by remote control, please point FM200 in the direction
of the receiver.
The desired volume can be set by turning this control knob. The currently set value is
shown in the display.
A brief press on the knob mutes the output.
In addition to volume control, this control knob is also used to configure the menus
for system settings and tone controls.
Format (e. g. PCM 44.1 kHz)
Device information /
Settings
47