(for use in the United States of America only)
Class B digital device – instructions:
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit
different form that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV
technician for help.
FCC Information
to the user
Service Menu
This menu can only be called up directly from the
machine's front panel.
Calling up the Service menu
• Switch the machine on using the
front panel.
• Hold the
button on the front panel pressed in
for about three seconds.
• You can now call up the following menu points in turn
using the
/
- RC ADR
Here you can change the remote control address of
the VSP 1250 R.
To alter the remote control address, first activate the
appropriate menu point by pressing the
button. Now change the setting using the
buttons and confirm your choice by pressing
the
button.
- CTRL VERS
Activate this menu point by pressing the
button, and the version number of the operating
processor will be displayed for about three seconds.
- VID VERS
Activate this menu point by pressing the
button, and the version number of the video process
will be displayed for about three seconds.
- FACTORY
Activate this menu point by pressing the
button, and the machine will be reset to the factory
default
settings.
automatically.
• Press the
button to close and quit the Service
menu.
56
button on the
buttons:
The
menu
is
/
terminated