Cleaning Instructions - ELECTRO FREEZE 876 Operator's Manual

ELECTRO FREEZE
6.2 Disassembly Instructions (cont.)
Figure 6-3
6.3

Cleaning Instructions

NOTE: It is your responsibility to be
aware of the requirements for meeting
federal, state and local laws concerning
the frequency of cleaning and sanitizing
your freezer.
1. Prepare a three compartment sink
for cleaning parts removed from the
freezer, per applicable health codes.
Also prepare a clean surface to air-dry
all parts.
184633
Models 876, 876B, 876C, 876RH, 876BRH, 876CRH & 875 Batch
Figure 6-4
CAUTION
Electric shock hazard. Do
not splash water on switches
or allow water to flow onto
electrical components inside
the machine.
8. Remove the beater assembly (figure
6-3) from the cylinder.
9. Remove scraper blades (2), springs
(3), shaft seal (5 and 6) and quad ring
(4) from the beater (1).
10. Remove the seal from the bushing on
the shaft seal assembly as shown in
figure 6-4.
11. Remove hopper cover, drip tray and
insert.
CAUTION
To prevent bacteria growth,
remove ALL O-rings when
cleaning. Failure to do so could
create a health hazard.
Important:
Do not use unapproved sanitizers
or laundry bleach. These materials
may contain high concentrations of
chlorine and will chemically attack
freezer components.
15