ELECTRO FREEZE 876 Operator's Manual page 38

ELECTRO FREEZE
13 Troubleshooting Tables
PROBLEM PROBABLE CAUSE
1. Freezer unplugged.
2.
Freezer does
not operate.
3. Beater motor out on overload.
4. Out on high pressure.
5. Component failure.
1.
Product will not
freeze. 2. Component failure.
3. Upper torque spring not connected.
184633
Models 876, 876B, 876C, 876RH, 876BRH, 876CRH & 875 Batch
Fuse or breaker blown at main
disconnect.
Improper mixing of product. Brix too
high.
(continued)
REMEDY
1. Plug in freezer.
Have service technician make
sure your freezer is connected to a
separate circuit independent from
any other electrical equipment.
2. Have service technician check
fuse or breaker size and check for
low voltage; if not within 10% of
nameplate rating call the power
company.
Allow motor to cool off, reset
circuit breaker, and check product
3.
consistency. See section 10.2,
Adjusting Product Consistency.
Contact your Electro Freeze
4.
Distributor for service.
Contact your Electro Freeze
5.
Distributor for service.
Follow mixing instructions on product
1. label. See Section 10.1, Determining
Product Consistency.
Contact your Electro Freeze Distribu-
2.
tor for service.
Install torque spring. See Section
3.
10.2, Adjusting Product Consistency.
43