ELECTRO FREEZE 876 Operator's Manual page 42

ELECTRO FREEZE
13.1
PROBLEM PROBABLE CAUSE
1. Shortage of refrigerant.
2. Dirty condenser.
3. Moisture in system.
Unit operates
long or
continuously.
4. Compressor failing.
5. Using too much alcohol.
6. Setting too cold.
1. Tubing rattling.
Noisy
Compressor.
2.
1. Improperly wired.
Compressor
will not
2. Low line voltage.
start – hums
intermittently
(cycling on
3.
overload).
4. High discharge pressure.
1. Voltage too low.
Start
capacitors
burned out.
2. Improper capacitor.
184633
Models 876, 876B, 876C, 876RH, 876BRH, 876CRH & 875 Batch
MTS Troubleshooting Tables
Motor off of internal springs. Springs
broken or bent.
Open starting capacitor or current
relay.
REMEDY
Contact your Electro Freeze
1.
Distributor for service.
Have condenser cleaned by your
2.
Electro Freeze distributor.
Contact your Electro Freeze
3.
Distributor for service.
Contact your Electro Freeze
4.
Distributor for service.
Check formula and adjust. (No more
5.
than 8% alcohol.)
6. Adjust warmer
Contact your Electro Freeze
1.
Distributor for service.
Contact your Electro Freeze
2.
Distributor for service.
Contact your Electro Freeze
1.
Distributor for service.
Contact your Electro Freeze
Distributor to check voltage. Check
2.
for other equipment on the same
circuit.
Contact your Electro Freeze
3.
Distributor for service.
Contact your Electro Freeze
4.
Distributor for service.
Contact your Electro Freeze
Distributor to check voltage. Check
1.
for other equipment on the same
circuit.
Contact your Electro Freeze
2.
Distributor for service.
47