ELECTRO FREEZE 876 Operator's Manual page 40

ELECTRO FREEZE
13 Troubleshooting Tables
PROBLEM PROBABLE CAUSE
1. Insufficient supply of mix.
2.
Freezer
vibrates
3. Worn blades.
4. Freezer not level.
5. Low on refrigerant.
1.
Poor or slow
2. Dispensing too much product too fast.
product
recovery.
3. Product too warm going into freezer.
4. Component failure.
Product in
1.
hopper freezes
1.
Product
temperature in
hopper rises
above 45°F.
2.
184633
Models 876, 876B, 876C, 876RH, 876BRH, 876CRH & 875 Batch
Improper mixing of product. Brix too
low.
Dirty or blocked condenser, restricted
air flow and/or high room temperature.
Models 876RH and 876BRH Only
(Refrigerated Hopper-RH)
Component out of adjustment or
component failure.
Product put in hopper was not
precooled.
Component out of adjustment or
component failure
(continued)
REMEDY
Fill hopper at least 1/3 full – keep
1.
hopper this full at all times.
Follow mixing instructions on product
2. label. See Section 10.2, Adjusting
Product Consistency.
3. Replace blades.
4. Level freezer.
Contact your Electro Freeze
5.
Distributor for service
Remove obstruction and/or lower
room temperature. Have condenser
1.
cleaned by your Electro Freeze
Distributor.
2. Check freezer capacity rating.
3. Precool – DO NOT FREEZE.
Contact your Electro Freeze
4.
Distributor for service
Contact your Electro Freeze
1.
Distributor for service
1. Precool product – DO NOT FREEZE.
Contact your Electro Freeze
2.
Distributor for service.
45