ELECTRO FREEZE
7
Assembly
14. Insert the door bushing (15) into
the door, then lubricate inside the
bushing.
15. Lubricate the door quad ring (14).
Then apply lubricant in four dots,
equally distanced, in the face recess,
and place the quad ring against the
lubricant.
NOTE: If the door does not slide
easily into place, recheck engagement
of beater with the drive shaft and door
bushing.
16. Line the door up so that end of beater
is in line with the door bushing hole.
Slide the door over the studs and
press in place against the quad ring.
Do not overtighten the hand knobs.
Excessive force will damage the door.
Tighten the hand knobs finger-tight
only.
17. Install the four hand knobs (2) on
the studs until they contact the door.
Draw knobs up equally and tighten
lightly, with finger pressure only!
184633
Models 876, 876B, 876C, 876RH, 876BRH, 876CRH & 875 Batch
(continued)
Important:
19