Operator Controls And Indicators - ELECTRO FREEZE 876 Operator's Manual

ELECTRO FREEZE
5

Operator Controls and Indicators

The following paragraphs describe the
operator controls and indicators. Refer to
figure 5-1 for location of these controls
and indicators on the freezer.
Figure 5-1
5.1 Selector Switch (1)
This three-position switch controls the
functions of your freezer.
a. "CLEAN" — This position operates
the beater only (no refrigeration).
Always use this position in all cleaning
and sanitizing operations.
b. "OFF" (center) — In this position
the beater motor and refrigeration
system will not operate.
5.2 Circuit Breaker– Reset
This control protects the beater motor
against failure from an overload condition
by automatically shutting down the
freezer. To restart the freezer properly,
turn the selector switch to "OFF", wait 2-3
minutes, then depress the reset button
and turn the selector switch back to the
"FREEZE" or "CLEAN" position.
184633
Models 876, 876B, 876C, 876RH, 876BRH, 876CRH & 875 Batch
Counter Models 876B, 876C,
876BRH, and 876CRH Floor Models 876 and 876RH
Do not use the "FREEZE" position with
water or sanitizer in the cylinder or
hopper. Freezing water or sanitizer in
the cylinder or hopper will damage the
freezer.
c. "FREEZE" — This position
activates both the beater motor and
refrigeration unit. This is the normal
operating position.
(2)
If the overload trips frequently,
your freezer should be checked for
proper product consistency and
voltage. Contact your Electro Freeze
Distributor.
Important:
Important:
11