Operator Controls & Indicators - ELECTRO FREEZE CS700-FG Operator's Manual

ELECTRO FREEZE Shake Model CS700-FG
5 Operator Controls
Figure 5-1
The following paragraphs describe the
operator controls and indicators. Refer to
figure 5-1 for location of these controls
and indicators on the freezer.
NOTE: The head and actuator rod must
be in place before the beater will operate.
5.1 Selector Switch (1)
This three-position switch controls the
operating mode of your freezer.
a.
position operates the beater only (no
refrigeration). Always use this mode
when performing cleaning and sanitizing
operations.
b.
position the beater motor and refrigeration
system will not operate.
10
"CLEAN" (left) — This
"OFF" (center) — In this
CAUTION
Test operation of the head
switch prior to placing
the freezer in service.
See Section 11, Routine
Maintenance, Monthly.
Important:
Do not use the "AUTO" position with
water or sanitizer in the cylinder — the
freezer will be damaged.
c. "AUTO" (right) — This
position activates both the beater motor
and refrigeration unit. This is the normal
operating position which will maintain a
cylinder temperature of 26° to 28°F (-3° to
-2°C).
—continued
185231-17