Installing The Table On The Benchtop Stand - SawStop RT-TGP Owner's Manual

Installing the Table on the Benchtop Stand

Requires:
Assembled Router Table and Benchtop Stand
Remaining Hardware from Benchtop Stand
If you wish to install the optional
1
Downdraft Dust Collection Box For
Router Lift, do so at this time, following
the instructions in your Four-Post
Router Lift with Lock manual. You can
download copies of your manuals at
www.sawstop.com.
Set the upside-down benchtop stand
2
on the upside-down router table, and
align the four threaded stand mounting
holes in the underside of the table with
the threaded hole at each end of the
assembled table. Make sure that the
front of the table (the side with the miter
slots) is facing the same direction as
the switchbox on the benchtop stand.
Attach the benchtop stand to the router
table using four socket head cap screws
(R), four lock washers (Q), and four
washers (J). Use a 5 mm hex wrench to
tighten the screws.
Turn over the table and stand, so the
3
stand rests on the four support feet.
Congratulations! You have completed the 27" x 16" Cast Iron Router Table – Benchtop Stand
Assembly and Installation. Continue to page 40 for next steps.
RT-TGP/RT-BT OWNER'S MANUAL
R
Q
J
18