SawStop RT-TGP Owner's Manual page 40

i
Once the rails are in place, you can mount the extension table to the rails. You will not use all the
hardware or brackets that are included with your 36" extension table. Follow the instructions in your
table saw fence manual to install the table. First, drill holes in the sides of the table to mount it to
the rails.
Place the extension table between the
2
rails and carefully slide it towards the
extension wing, making sure it does
not fall. The extension table mounts to
the rails with bolts that pass through
holes in the rails and extension table.
Take two M8 x 1.25 x 40 flat head
socket screws from your extension table
hardware, and insert one through the
hole in the front rail closest to the saw
and the other through the hole in the
rear rail closest to the saw. Place an M8
washer, M8 lock washer, and an M8 hex
nut on the threaded end of each bolt,
keeping them loose.
Use a level or straight edge to make
3
sure the extension table is flush with the
right wing of your saw. Then use two
C-clamps to secure the right end of the
extension table to the rails. Mark the
extension table in the center of each of
the holes in the front and rear rails.
35
RT-TGP/RT-BT OWNER'S MANUAL
front rail
front rail
clamp
table to
front rail
rear rail
clamp table
to rear rail
rear rail