SawStop RT-TGP Owner's Manual page 35

Attach the intermediate cast iron wing
5
to the front and rear rails. Insert a flat
head socket screw (6.2) through the
exposed mounting hole in the front
rail and front edge of the intermediate
cast iron wing. Secure the screw with
a washer (6.3), a lock washer (6.4), and
a hex nut (6.5). Repeat this process for
the exposed mounting hole in the rear
rail and intermediate cast iron wing.
Only finger tighten the nuts at
this time.
Lay a straight edge across the front of
6
the extension wing so that it extends
over the top of the intermediate cast
iron wing.
To adjust for a flush installation, push
down or pull up on the intermediate
cast iron wing and then tighten the
nuts to hold it in place. Make sure the
intermediate cast iron wing is flush with
the top of the extension wing and then
use two 13mm wrenches to tighten the
hex head bolt and hex nut closest to the
front of the extension wing. Use a 5mm
hex wrench and a 13mm wrench to
tighten the socket head screw and hex
nut at the front edge of the intermediate
cast iron wing.
Repeat the process at the rear of the
extension wing, then recheck both ends
and tighten the two center bolts and
hex nuts.
6.2
6.3
6.4
6.5
RT-TGP/RT-BT OWNER'S MANUAL
30