SawStop RT-TGP Owner's Manual page 44

i
The hardware for the next steps can be found in the "Rail Mounting Hardware" bag from your Power
Switch for In-Line Router Tables (RT-PSW) box.
Next, mount the router table to the front
13
and rear rails of your saw. Insert two flat
head socket screws (4.17) through the
holes in the front rail and router table.
Secure the screws with two washers
(4.18), two lock washers (4.19), and two
hex nuts (4.20). Repeat the previous
step for the holes in the rear rail and
rear edge of the cast iron table. Use a
5mm hex wrench and a 13mm wrench
to tighten the hex nuts.
14
See your table saw fence manual for instructions on how to re-tighten the hardware
securing your rear rail to your table saw and how to reinstall the main tube. It is very
important to install and align the front tube correctly.
Congratulations! You have completed the In-Line Right: Between PCS 52" Rails Installation.
Continue to the following page for the next steps.
39
RT-TGP/RT-BT OWNER'S MANUAL
4.17
4.18
4.19
4.20