SawStop RT-TGP Owner's Manual page 42

Use a 3/8" drill bit to drill holes in the
8
edge of the 36" extension table at the
three spots you marked in the previous
step, as indicated by the red arrows.
Align the three lower holes in the router
9
table with the holes you just drilled in
the 36" extension table.
i
The hardware for the next steps can be found in the "Wing Mounting Hardware" bag from your Power
Switch for In-Line Router Tables (RT-PSW) box. You will not use all the hardware to attach the cast iron
table to the extension table.
Next, mount the router table to the 36"
10
extension table. Insert three hex head
bolts (4.13) through three washers
(4.14), then through the router table and
36" extension table. Secure the bolts
with three more washers (4.14), three
lock washers (4.15), and three hex nuts
(4.16). Only finger tighten the hex nuts
at this time.
37
RT-TGP/RT-BT OWNER'S MANUAL
4.16
4.15
4.14
4.13