SawStop RT-TGP Owner's Manual page 26

Insert a hex head bolt (4.2) through a
5
washer (4.3), then through one of the
exposed mounting holes in the leg
mounting bracket (4.7) and support
leg (3.1), through another washer (4.3),
and then through a lock nut (4.4).
Repeat this process for the other set
of exposed mounting holes in the
bracket and support leg. Use two 17mm
wrenches to tighten the lock nuts on
the bolts.
Next, mount the handle mounting
6
bracket (4.11) to the front of the leg
mounting bracket without the power
switch (4.7). Align the square hole in the
handle mounting bracket with the left of
the two holes in the front of the bracket.
Insert the shorter pan head Phillips
7
screw (4.12) through one of the two
smaller lock washers (4.9) and a washer
(4.10), then through the exposed
mounting holes in the handle mounting
bracket and leg mounting bracket. Use
a Phillips screwdriver to secure the
screw.
21
RT-TGP/RT-BT OWNER'S MANUAL
4.2
4.3
3.1
4.11
4.9
4.12
4.10
4.3 4.4
4.7
4.7