SawStop RT-TGP Owner's Manual page 49

i
If there is excess dust hose length between the 27" fence and the Downdraft Dust Collection Box for
Router Lift, you can shorten the dust hose.
When making jointer cuts, it can be
useful to offset one router fence face
plate (5.14) relative to the other router
fence face plate. Two fence face plate
space bars (5.13) are used to do this,
and they can be installed to offset
the router fence face plates by either
0.7mm or 1.5mm. It is important to
install both fence face plate space
i
bars facing the same direction, so they
both extend either 0.7mm or 1.5mm
beyond the edge of the fence. To install
the fence face plate space bars (5.13),
loosen the three lock knobs (5.6) on
one side of the back of the router table
fence (5.1), and slide the two fence face
plate space bars onto the two T-shaped
extensions behind the fence face plate.
Then re-tighten the three lock knobs to
secure the fence face plate in place.
Congratulations! You have completed the assembly for the 27" Fence Assembly for Router Tables.
Your router table setup is now complete.
5.1
5.13
5.6
5.13
RT-TGP/RT-BT OWNER'S MANUAL
44